Skip to main content
PPEReviewed against current OSHA standards

PPE Training Under 1910.132(f): What You Must Teach, Demonstrate, and Write Down

OSHA 1910.132(f) requires PPE training, a hands-on demonstration, retraining triggers and a written certification. Here is what small employers must cover.

Updated October 19, 2026
7 min read
By the WorkSafely safety team

A new hire starts Monday at your fabrication shop. On Monday morning someone hands over safety glasses, gloves, and a pair of earplugs, says "wear these around the grinder," and goes back to a customer call. By Wednesday the earplugs are in a pocket, the glasses are pushed up on a forehead, and nobody is sure whether the gloves are meant for the grinder at all. Nothing dramatic has happened yet. But if an inspector walks in that day and asks what training the employee received, "I handed him the gear" is not an answer the standard accepts.

Most small employers are comfortable with the idea that they have to supply protective equipment. Fewer realize that 29 CFR 1910.132(f) is a separate obligation: before a worker is required to wear PPE, the employer has to teach the worker how to use it, confirm that the teaching worked, and keep a written record. This post is about that paragraph specifically. If you are looking for the earlier step, deciding which PPE a job needs in the first place, see our post on the PPE hazard assessment under 1910.132(d). If your question is who pays, that is covered in who pays for PPE under 1910.132(h).

What 1910.132(f) actually requires

The standard says the employer must provide training to each employee who is required by the standard to use PPE. It then lists what that training has to cover. A worker must know when PPE is necessary, what PPE is necessary, how to put it on, take it off, adjust it, and wear it properly, what its limitations are, and how to care for it, maintain it, and know its useful life and how to dispose of it.

Read that list as a set of questions the employee should be able to answer without looking at a poster. When is it necessary: at which tasks, in which areas? What is necessary: which glove for the solvent, which for the sheet metal edge? How does it go on: how does a respirator seal check, how does a face shield sit over safety glasses? What can it not do: a dust mask will not help against vapors, a cut-resistant glove will not stop a puncture from a pointed tool. And what happens at the end of its life: how does the worker recognize that a cracked lens, a stiff glove, or a worn-out earplug is finished, and where does a replacement come from?

Notice that the standard is written around the employee's understanding, not around your delivery. The goal is a worker who can do these things, not a binder that says they were told.

The demonstration requirement

The second part of the paragraph is the one that catches the "handed him the gear" approach. Each employee has to demonstrate that they understand the training and can use the PPE properly before they are allowed to perform work that requires it.

That sentence has two consequences for a small business. First, training cannot be a video playing in the break room while the new hire is already working at the machine. The sequence matters: training, demonstration, then the work. Second, the demonstration should be something you can actually observe. Ask the worker to put on and adjust the equipment while you watch. Ask them to explain in their own words why the faceshield goes over the glasses and not instead of them. Ask what they would do if the strap on their harness, glove, or respirator looked damaged. A short conversation at the workstation, with the actual equipment in hand, does more than a printed quiz.

Hands-on demonstration is a theme across OSHA training requirements, and we cover the general principle in our post on hands-on demonstration in OSHA training. For PPE it is simple to do well, because the equipment is right there and the check takes minutes.

When retraining is required

Training under this paragraph is not a one-time event attached to the hire date. The standard says an employer must retrain an employee when the employer has reason to believe that a previously trained employee who has already been trained does not have the understanding and skill required to use PPE properly. It lists specific situations that signal this: changes in the workplace that make previous training obsolete, changes in the types of PPE to be used that make previous training obsolete, and inadequacies in an affected employee's knowledge or use of assigned PPE that indicate the employee has not retained the necessary understanding or skill.

Think about how these show up on an ordinary shop floor. You switch glove suppliers and the new glove is a different material with a different chemical rating. The old training described the old glove. You add a new process, say you start using a cleaning solvent that requires splash protection that wasn't needed before. Or a supervisor notices, on a walkaround, that the same worker keeps wearing the faceshield pushed up above the eyes. Each of those is a prompt to retrain. The third is the one most often ignored: observed misuse is itself the trigger, and the standard does not wait for an injury.

Note also what the standard does not say. It does not set an annual refresher schedule for general PPE. Some other standards do set refreshers, respiratory protection being an example, with its own annual requirements under 1910.134. But under 1910.132(f), the trigger is a reason to believe the training did not take or no longer fits, which puts the responsibility on whoever supervises the work to actually watch.

The written certification

The last piece is paperwork, and it is lighter than many owners fear. The employer has to verify that each affected employee has received and understood the required training through a written certification. The certification has to contain the name of each employee trained, the date or dates of training, and the subject of the certification.

That is three facts. A sign-in sheet that says "PPE training: eye and face protection, hand protection, hearing protection," with a date and the names of the workers, meets the described content. It helps to add the trainer's name and a line noting the demonstration was observed, because those answer the follow-up questions an inspector or an insurer is likely to ask, but those additions are good practice, not text from the standard.

One practical point: when retraining occurs, certify it again with a new date. A single certification from three years ago does not document that you responded to the new gloves or the new solvent.

Putting it into a rhythm

For a small shop, the cleanest way to meet this paragraph is to tie it to events you already manage. At hiring, build PPE training and the demonstration into the first day, before the worker starts any task that requires equipment. At each change of process, material, or supplier, ask one question: does what we taught still match what we hand out? On supervisor walkarounds, treat misuse as a signal for a short retraining conversation rather than a reprimand alone.

A brief toolbox talk is a natural vehicle for the teaching part. Our toolbox talk template gives you a reusable five-minute outline you can point at a single piece of equipment, such as eye and face protection or hearing protection, and it makes the date and attendee list easy to capture. Pair it with the PPE hazard assessment checklist, which documents which PPE each task needs, so your training content and your assessment tell the same story.

None of this requires a safety department. It requires someone with the authority to say "not until you've shown me" on a worker's first day, and the habit of writing the date down.

What to take away

The standard has four moving parts: teach the listed topics, have each employee demonstrate understanding before the work, retrain when the workplace, the equipment, or the worker's observed behavior shows the earlier training no longer fits, and certify in writing with names, dates, and subject. If your current practice is handing out gear with a verbal reminder, the gap is usually the demonstration and the record, both of which cost minutes rather than money.

This post is general information about one paragraph of a federal standard. It is not legal advice, and your obligations can vary with your industry, your state plan, and the equipment you use, so confirm the current text of 29 CFR 1910.132 before you rely on any detail here.

Related reading: PPE hazard assessment | Who pays for PPE | Hands-on demonstration requirements

OSHA standards cited

Always verify current OSHA standards at osha.gov. This article reflects standards in effect at the date of publication.

Not sure where you stand?

Take the 5-minute compliance assessment. Answer a few questions about your business and get a prioritized list of what OSHA expects, free.

Start free assessment